●
Speakers (see
●
USB board (see
●
Power connector cable (see
●
Display assembly (see
NOTE:
When replacing the system board, be sure that the following components are removed from
the defective system board and installed on the replacement system board:
●
Memory module (see
●
RTC battery (see
●
Fan/heat sink assembly (see
●
Processor (see
Remove the system board:
1.
Disconnect the optical drive connector cable from the system board.
2.
Remove the Phillips PM2.5×6.0 screw (1) that secures the system board to the base enclosure.
3.
Lift the right side of the system board (2) until it rests at an angle.
74
Chapter 4 Removal and replacement procedures
Speakers on page
USB board on page
Power connector cable on page
Display assembly on page
Memory module on page
RTC battery on page
Fan/heat sink assembly on page
Processor on page
86)
61)
63)
66)
45)
78)
64)
80)