Computer Setup Menus; File Menu - HP Probook 5310m Maintenance And Service Manual

Computer Setup
Restoring factory settings in Computer Setup
✎
Restoring defaults will not change the hard drive mode.
To return all settings in Computer Setup to the values that were set at the factory, follow these steps:
1. Turn on or restart the computer, and then press
displayed at the bottom of the screen.
2. Press to enter BIOS Setup.
f10
3. Use a pointing device or the arrow keys to select File > Restore Defaults.
4. Follow the on-screen instructions.
5. To save your changes and exit, click the Save icon in the lower-left corner of the screen, and then follow the
on-screen instructions.
– or –
Use the arrow keys to select File > Save Changes and Exit, and then press
Your changes go into effect when the computer restarts.
✎
Your password settings and security settings are not changed when you restore the factory settings.

Computer Setup menus

The menu tables in this section provide an overview of Computer Setup options.
✎
Some of the Computer Setup menu items listed in this chapter may not be supported by your computer.

File menu

Select
System Information
Restore Defaults
Reset BIOS security to factory default
Ignore Changes and Exit
Save Changes and Exit
5–8
while the "Press the ESC key for Startup Menu" message is
esc
To do this
■ View identification information for the computer and the
batteries in the system.
■ View specification information for the processor, memory
size, system ROM, video revision, keyboard controller
version, and wireless identification numbers.
Replace the configuration settings in Computer Setup with
the original factory settings. (Hard drive mode, password
settings, and security settings are not changed when you
restore the factory settings.)
Resets password to the factory default in case of a forgotten
password.
Cancel any changes entered during the current session. Then
exit and restart the computer.
Save any changes entered during the current session. Then
exit and restart the computer. Your changes go into effect
when the computer restarts.
enter .
Maintenance and Service Guide