HP Probook 5310m Maintenance And Service Manual page 84

Removal and replacement procedures
9. If it is necessary to replace the WLAN antenna transceivers and cables:
a. Detach the WLAN antenna transceivers 1 from the display enclosure. (The transceivers are attached to the
enclosure with double-sided tape.)
b. Release the WLAN antenna cables 2 from the clips and routing channel built into the left and right sides of
the display enclosure.
c. Remove the WLAN wireless antenna transceivers and cables. The wireless antenna transceivers and cables
are included in the Display Cable Kit, spare part number 581093-001.
10. If it is necessary to replace the microphones and cables:
a. Release the microphone receivers 1 from the clips built into the display enclosure.
b. Release the microphone cables 2 from the clips and routing channel built into the left side of the
display enclosure.
c. Remove the microphones and cables. The microphones and cables are included in the Display Cable Kit,
spare part number 581093-001.
Reverse this procedure to reassemble and install the display assembly.
4–48 Maintenance and Service Guide