Remove the keyboard:
1. Position the computer with the front toward you.
2. Remove the following screws:
❏
Two Torx T8M2.5×5.0 screws 1 in the mass storage device bay and the wireless module compartment
❏
One Phillips PM2.5×2.0 broadhead screw 2 in the battery bay
❏
One Torx T8M2.5×9.0 screw 3
3. Turn the computer display-side up, with the front toward you.
4. Open the computer as far as possible.
5. Lift the rear edge of the keyboard 1 until it rests at an angle.
6. Slide the keyboard 2 back until it rests on the display.
Maintenance and Service Guide
Removal and replacement procedures
4–23