HP 4510s - ProBook - Celeron 1.8 GHz Maintenance And Service Manual page 125

Service guide
Hide thumbs Also See for 4510s - ProBook - Celeron 1.8 GHz:
Table of Contents

Advertisement

g.
Optical drive (see
h.
Display assembly (see
Display assembly on computers with 14-in displays on page
i.
Top cover (see
When replacing the system board, be sure that the following components are removed from the defective
system board and installed on the replacement system board:
Memory module (see
WLAN module (see
WWAN module (see
Modem module (see
Processor (see
Processor on page
Remove the system board:
1.
Position the computer right-side up with the front toward you.
2.
Disconnect the following cables from the system board:
(1) Bluetooth module cable
(2) USB connector module cable
(3) RJ-45 cable
(4) SIM board
(5) Power cable
3.
Lift the rear edge of the system board (1) until it rests at an angle.
Optical drive on page
Display assembly on computers with 15-in displays on page 84
Top cover on page
90)
Memory module on page
WLAN module on page
WWAN module on page
Modem module on page
110)
69)
97)
68)
80)
74)
103)
Component replacement procedures 113
or

Advertisement

Table of Contents
loading

This manual is also suitable for:

Probook 441sProbook 4410s

Table of Contents