Miscellaneous - HP A6110n - Pavilion - 2 GB RAM Troubleshooting And Maintenance Manual

Performance (continued)
Symptom
Applications and files take
longer to open or respond.
(continued)

Miscellaneous

Symptom
Insufficient memory message
displays.
Remote sensor is not receiving
a signal from the remote
control (select models only).
22
Troubleshooting and Maintenance Guide
Possible solution
Check for hard disk drive errors:
1 Close all open programs and windows.
2 Click the Windows Start Button, and then click Computer.
3 Right-click the hard disk drive that you want to check, and then click
Properties.
4 In the System Properties window, click the Tools tab.
5 Under Error-checking, click Check Now.
6 If desired, select the buttons next to Automatically fix file system
errors and Scan for and attempt recovery of bad sectors.
7 Click Start. If prompted to restart, click Yes and allow the computer
to restart.
Possible solution
Close all open programs, and then try the desired task
again, or restart your computer (click the Windows Start
Button, click the Arrow button next to the Lock button,
and then click Restart). If the message displays again,
consider purchasing and installing additional memory.
1 Click the Windows Start Button, right-click Computer, and then
select Properties.
2 Under Tasks, click Device Manager.
3 Click the plus (+) sign next to Universal Serial Bus Controllers.
4 If the eHome Infrared Receiver is listed under Universal Serial Bus
Controllers, Windows Vista is properly detecting the IR Receiver. If it is not
listed, go to the next step.
5 Unplug the end of the USB cable on the remote sensor from the computer
and plug it into the same USB port.
6 Disconnect all other USB devices, leave the remote sensor plugged in, and
then restart the computer. Plug in other USB devices after the remote sensor
appears in the Device Manager window.