Removal and replacement procedures
Speaker
Description
Speaker
Before removing the speaker, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. SIM (see
b. Hard drive cover (see
c. Keyboard (see
d. Hinge cover (see
e. Top cover (see
f. Audio connector board (see
g. Bluetooth module (see
Remove the speaker:
1. Disconnect the speaker cable
2. Remove the speaker cable from the clips
3. Remove the Phillips PM2.0×5.0 screw
4. Remove the speaker
Reverse this procedure to install the speaker.
4–26
"Battery" on page
"SIM" on page
4-9)
"Hard drive" on page
"Keyboard" on page
"Hinge cover" on page
"Top cover" on page
"Audio connector board" on page
"Bluetooth module" on page
from the system board.
from the base enclosure.
4-8).
4-10)
4-17)
4-20)
4-21)
4-25)
built into the base enclosure.
that attaches the speaker to the base enclosure.
Spare part number
507057-001
4-24)
Maintenance and Service Guide