Audio Connector Board - HP 2730p - EliteBook - Core 2 Duo 1.86 GHz Maintenance And Service Manual

Removal and replacement procedures

Audio connector board

Description
Audio connector board (includes cable)
Before removing the audio connector board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. SIM (see
b. Hard drive cover (see
c. Keyboard (see
d. Hinge cover (see
e. Top cover (see
Remove the audio connector board and cable:
1. Release the ZIF connector
connector board cable
connector board and is also available in the Cables Kit, spare part number MCK-001.
2. Remove the Phillips PM2.0×5.0 screw
3. Remove the audio connector board and cable
Reverse this procedure to install the audio connector board.
4–24
"Battery" on page
"SIM" on page 4-9)
"Hard drive" on page
"Keyboard" on page
"Hinge cover" on page
"Top cover" on page
to which the audio connector board cable is connected, and disconnect the audio
from the system board. The audio connector board cable is included with the audio
4-8).
4-10)
4-17)
4-20)
4-21)
that secures the audio connector board to the base enclosure.
.
Spare part number
507056-001
Maintenance and Service Guide