GE JGB900 - Appliances 30 in. Gas Range Owner's Manual page 53

ge.com
Possible Causes
Display goes blank
A fuse in your home may be
blown or the circuit
breaker tripped.
The clock is in the
* See
tile
Special features of your oven control
section.
black-out mode.
Display flashes
Power failure. • Reset the clock.
Unable to get the
Oven control pads were * The BAKE and
BROILHI/LO
pads must be touched ;it
display
to show "SF"
not pressed properly, tile same time
and
held for 3 seconds.
Power outage, Power outage or surge. • Reset the clock./f the oven was in use vet! must reset
clock flashes it by, touching, the CLEAR/OFFpad, ,settim_ the clock
and resetting any cooking flmction.
"Burning" or "oily"
This is normal in a new oven * To speed tile process, set a selFclean cycle fin" a
odor emitting from
and will disappear in time. minimmn of _4 hot/Ys. See tile
Using the self-cleaning
the vent oven section.
Strongodor
An odor from the insulation * This is
[ell/l)Ol';ll'y.
around the inside of the oven
is normal for the first few times
the oven is used.
Fan noise
(some models)
The convection fan may turn on • This is normal. Tile conve(tion thu will run until tile
and off automatically, tmwtion is over or tile door is opened.
Convection fan not
Preheat temperature • Fan will start automatically once tile preheat
working (some models)
not reached,
tenlperatuI'e is reached.
Drawer does not slide The drawer is out of alignment. * Fully extend the drawer and push it ;ill tile way in.
smoothly or drags See tile Care and cleaning of the range section.
Drawer is over-loaded or load • Reduce weight. Redistribute drawer contents.
is unbalanced.
Warming drawer will A fuse in your home may be • Replace tile fl/se i)r reset tile circuit breaker.
not work
blown or the circuit breaker
tripped.
The oven is self-cleanh_g. • Wait fro" the sell:clean cycle to finish and tile oven
to cool.
Controls improperly set. • See the
Electric warming drawer
section.
Excessive condensation Liquid in warming drawer. • Remove liquid.
in the warming drawer
Uncovered foods.
• Cover
tbod with
lid or ahuninmn
foil.
Temperature setting too high. • Reduce temperatm'e settin,_
Food dries out in the Moisture escaping. • Cover food with lid or aluminmn foil.
warming drawer
What To Do
• Replace the tilse
or reset
the circuit breaker:
53
+
iiiiiiiiiiiiiii!!ii+ +
Iiiii ii i_