Entering The Wwn Checksum; Entering The Storage System Password - HP 6100 User Manual

NOTE:
the controller is booting. It may take up to two minutes for the steps to display. The default
WWN entry display has a 0 in each of the 16 positions.
4. Press
and select the next.
5. Repeat Step 4
6. Press Enter to accept the WWN and select the checksum entry mode.

Entering the WWN checksum

The second part of the WWN entry procedure is to enter the two-character checksum, as follows.
1. Verify that the initial WWN checksum displays 0 in both positions.
2. Press
and select the second character.
3. Press
exit.
4. Verify that the default display is automatically selected. This indicates that the checksum is
valid.
NOTE: If you enter an incorrect WWN or checksum, the system will reject the data and you must
repeat the procedure.

Entering the storage system password

The storage system password feature enables you to restrict management access to the storage
system. The password must meet the following requirements:
8 to 16 characters in length
Can include upper or lower case letters
Can include numbers 0 - 9
Can include the following characters: ! " # $ % &amp ' ( ) * + , - . / : ; < = > ? @ [ ] ^ _ ` {
| }
Cannot include the following characters: space ~ \
NOTE: You must be running HP Command View EVA 6.0 or later to use passwords of more than
eight characters. HP Command View EVA 8.0.1 is required with XCS 6.200. If you set a password
longer than eight characters, you will no longer be able to manage the storage system with an
earlier version of HP Command View EVA. In this case, it will be necessary to clear the long
password and reenter a password of no more than eight characters.
Complete the following procedure to enter the password:
1. Select a unique password of 8 to 16 characters.
2. With the default menu displayed, press
3. Press to display Change Password?
4. Press Enter for yes.
The default password, AAAAAAAA~~~~~~~~, is displayed.
5. Press
6. Press to accept this character and select the next character.
7. Repeat the process to enter the remaining password characters.
8. Press Enter to enter the password and return to the default display.
24 Enterprise Virtual Array startup
Notifications of the startup test steps that have been executed are displayed while
or until the first character of the WWN is displayed. Press
to enter the remaining characters.
or until the first checksum character is displayed. Press
or until the second character is displayed. Press Enter to accept the checksum and
or to select the desired character.
three times to display System Password.
to accept this character
to accept this character