Table of Contents
Advertisement
Quick Links
12 volt Jump-start
and power supply
set up and operating instructions
visit our website at: http://www.harborfreight.com
read this material before using this product.
Failure to do so can result in serious injury.
save this manual.
Copyright
2009 by Harbor Freight Tools
©
contained herein may be reproduced in any shape or form without the express written consent of
Harbor Freight Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing
improvements, actual product may differ slightly from the product described herein. Tools required for
assembly and service may not be included.
For technical questions or replacement parts, please call 1-800-444-3353.
38391
. All rights reserved. No portion of this manual or any artwork
®
note: after purchase
and before initial use
of the Jump-start,
fully charge the Jump-
start battery until the
dc charging led
turns off.
after each jump start,
fully recharge the
battery until the dc
charging led turns
off.
Fully charge Jump-
start battery every 30
days to ensure long
battery life.
Advertisement
Table of Contents
Related Manuals for Chicago Electric 38391
Summary of Contents for Chicago Electric 38391
- Page 1 12 volt Jump-start and power supply 38391 set up and operating instructions note: after purchase and before initial use of the Jump-start, fully charge the Jump- start battery until the dc charging led turns off. after each jump start, fully recharge the...
-
Page 2: Specifications
The handles in damp or wet locations. Don’t must be kept clean, dry, and free from expose to rain. Keep work area well oil and grease at all times. SKU 38391 For technical questions, please call 1-800-444-3353. Page 2... - Page 3 Call for pacemaker failure. medical assistance and continue flushing the effected areas until medical help arrives. the on/off switch (see Figure 1, next page) regulates power to the SKU 38391 For technical questions, please call 1-800-444-3353. Page 3...
-
Page 4: Controls And Components
LED to clamps only. Keep it in the “Off” prevent overcharging. Leave the unit position except when jumpstarting. plugged in to make sure it is charged for emergencies. SKU 38391 For technical questions, please call 1-800-444-3353. Page 4... -
Page 5: Operation
Small Power Tool, Bilge Pump Electric Cooler Air Compressor, Vacuum Figure 3 Charge the unit for the minimal time needed (to at least 14 volts). Store the Cigarette Lighter Adapter when finished. SKU 38391 For technical questions, please call 1-800-444-3353. Page 5... - Page 6 Start. Then, disconnect the red (+) Clamp and return it to its position on the Jump-Start. After each jump start, fully recharge the Jump-Start battery until the DC Charging LED turns off. SKU 38391 For technical questions, please call 1-800-444-3353. Page 6...
-
Page 7: Maintenance
Only use with battery packs Snap the lens/bezel into place. distributed by Harbor Freight Tools; others may burst, causing personal injury and/or property damage. For additional information on battery recycling call 1-800-822-8837. SKU 38391 For technical questions, please call 1-800-444-3353. Page 7... - Page 8 THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. note: Some parts are listed and shown for illustration purposes only and are not available individually as replacement parts. SKU 38391 For technical questions, please call 1-800-444-3353. Page 8...
-
Page 9: Limited 90-Day Warranty
This warranty gives you specific legal rights and you may also have other rights which vary from state to state. 3491 Mission Oaks Blvd. • PO Box 6009 • Camarillo, CA 93011 • (800) 444-3353 SKU 38391 For technical questions, please call 1-800-444-3353. Page 9...