HP Ew2400 - JetDirect Print Server Administrator's Manual page 90

Table 3.4 Telnet Commands and Parameters (12 of 18)
phone-home-config
TCP/IP Diagnostics
Command
Last Config IP
TCP Conns Refused (Read-only parameter) The number of client TCP
TCP Access Denied
DHCP Lease Time
DHCP Renew Time
DHCP Rebind Time
SNMP
Command
snmp-config
get-cmnty-name
ENWW
Specifies privacy settings on the print server during
embedded Web server access. This command controls
whether statistical data on product use may be sent to HP.
For HP to collect data, Internet access is required.
2: Prompt the user to allow sending data on initial access to
the Networking tab of the embedded Web server. This is the
factory-default and cold-reset value. Once changed, this
value cannot be re-selected.
1: Allows the sending of data to HP without prompting the
user.
0: Disables sending data to HP without prompting the user.
Description
(Read-only parameter) The IP address of the system from
which the HP Jetdirect print server's IP address was
configured.
connections that are refused by the print server.
(Read-only parameter) The number of times that client
systems were denied access to the print server because
there was no allowable entry in the print server's host access
list.
(Read-only parameter) DHCP IP address lease duration
time (seconds).
(Read-only parameter) DHCP T1 timeout, specifying the
DHCP lease renewal time (seconds).
(Read-only parameter) DHCP T2 timeout, specifying the
DHCP lease rebind time (seconds).
Description
Enables or disables SNMP operation on the print server.
0 disables, 1 (default) enables SNMP.
CAUTION: Disabling SNMP will disable all SNMP agents
(SNMP v1, v2, v3) as well as communications with
management applications, such as HP Web Jetadmin. In
addition, firmware upgrades through current HP
downloading utilities will be disabled.
Specifies a password that determines which SNMP
GetRequests the HP Jetdirect print server will respond to.
This is optional. If a user-specified get community name is
set, the print server will respond to either a user-specified
community name or the factory-default. The community
name must be ASCII characters. The maximum length is
255 characters.
TCP/IP Configuration 90