HP Ew2400 - JetDirect Print Server Administrator's Manual page 89

Table 3.4 Telnet Commands and Parameters (11 of 18)
gw-disable
default-ip
default-ip-dhcp
dhcp-fqdn-config
dhcp-fqdn-behavior
dhcp-arbitration
ENWW
Specifies whether or not to automatically assign the device
IP address as the gateway when a network gateway is not
configured.
0: A gateway using the device IP address will be assigned.
1: A gateway is not assigned. The gateway address 0.0.0.0
will be configured.
Specifies the IP address to use when the print server is
unable to obtain an IP address from the network during a
forced TCP/IP reconfiguration (for example, when powered
off/on or manually configured to use BOOTP/DHCP).
DEFAULT_IP: sets the legacy default IP address
192.0.0.192.
AUTO_IP: sets a link-local IP address 169.254.x.x.
The initial setting is determined by the IP address obtained
when first powered on.
Specifies whether DHCP requests will be periodically
transmitted when a legacy default IP address 192.0.0.192
or link-local IP address 169.254.x.x has been automatically
assigned.
0: Disables DHCP requests.
1 (default): Enables DHCP requests.
Specifies configuration control of the Fully Qualified Domain
Name (FQDN), using either DHCP, manual configuration,
or both. The fully qualified domain name consists of the
device's host name and domain name. Select one of the
following command values:
0 (default): DHCP may be used to supply the host name and
domain name. The host name may be changed using a
manual configuration method (such as the embedded Web
server, printer control panel, or Telnet). However, the
domain name cannot be manually changed if it was
configured through DHCP.
1: Keep DHCP settings only. Once the Fully Qualified
Domain Name is configured through DHCP, manual
changes cannot be made.
2: Keep manual settings. The settings can be manually
configured. DHCP may be used only if the settings are
factory-default values.
3: Keep manual settings only. While manual configuration
methods may be used, configuration through DHCP is not
allowed.
Specifies the amount of time, in seconds, that the print
server will wait for DHCP configuration offers. A value from
1 to 10 may be set. The default is 5 seconds.
TCP/IP Configuration 89