Reassembling the Library
After replacing the transport assembling and reconnecting the modules,
complete the following:
1. Reattach the interconnect cable between the bottom two modules (see
2. Replace the screws that secure the retainer brackets on the bottom
3. Replace the library side panels on the bottom two modules (see
4. Replace the side panels on the cabinet (see Figure 2-16 on page 2-38).
5. Replace the shipping brackets (see Figure 2-19 on page 2-42).
6. Replace the external cables and power cord on the bottom module.
If the new transport assembly has a different version of firmware than the
NOTE
rest of the library, the library could go into a partial availability state due
to a firmware mismatch. When this occurs, the front panel will display
Partly Available
solid amber. This is not an indication of a failure, but indicates that you
need to download new library firmware.
Chapter 2
Removing and Replacing the Transport Assembly (for Model 12/140 only)
Figure 2-18 on page 2-41).
module to the cabinet (see Figure 2-20 on page 2-43).
Figure 2-17 on page 2-39).
, and the LED bar beneath the front panel display will be
Removing and Replacing Major Library Components
2-47