Removing And Replacing The Transport Assembly; Accessing The Side Panels For Service - HP A5585A - SureStore DLT E Tape Library 4/40 Upgrade And Replacement Instructions

WARNING
AVERTISSEMENT
Removing and Replacing Major Library Components
Removing and Replacing the Transport Assembly (for Model 12/140 only)
Removing and Replacing the Transport
Assembly (for Model 12/140 only)
Level of Difficulty: [5] Difficult
The transport assembly involves two replaceable parts: the transport
assembly and the vertical lift assembly. Either assembly may be
replaced separately, but both must be removed to service either part. See
page 2-48 for instructions on replacing the vertical lift assembly.
The instructions for replacing the transport assembly are divided into
the following sections:
• "Accessing the Side Panels for Service" on page 2-36
• "Accessing the Transport Assembly" on page 2-40
• "Replacing the Transport Assembly" on page 2-45
• "Replacing the Transport Assembly" on page 2-45
• "Re-installing the Bottom Module" on page 2-46

Accessing the Side Panels for Service

The library can be serviced by removing the side and bottom panels on
the cabinet and library. You will not need to access the top of the library
to service this product.
To access the library from the sides:
1. Extend the anti-tip rails, which are located at the bottom of the
library cabinet. After extending these rails, lower the leveler feet to
keep the library cabinet from moving when you are servicing it.
Failure to extend the anti-tip device could result in personal
injury or damage to the tape autoloader if the rack tips over.
Si vous ne déployez pas le dispositif antibasculant, le rack risque de
se renverser et de provoquer des blessures ou d'endommager
l'autochargeur de bande.
2-36 Chapter 2