Memory Module - HP 2710p - Compaq Business Notebook Maintenance And Service Manual

Memory module

Description
2048-MB (PC2-5300, 667-MHz, DDR2)
1024-MB (PC2-5300, 667-MHz, DDR2)
512-MB (PC2-5300, 667-MHz, DDR2)
Before removing the memory module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the hard drive compartment cover (see
Remove the memory module:
1. Spread the retaining tabs (1) on each side of the memory module slot to release the memory
module. (The edge of the module opposite the slot rises away from the computer.)
2. Remove the memory module (2) by pulling the module away from the slot at an angle.
NOTE:
memory module slot.
Reverse this procedure to install the memory module.
Battery on page
Memory modules are designed with a notch (3) to prevent incorrect installation into the
39).
Hard drive on page
Component replacement procedures
Spare part number
454673-001
454672-001
454674-001
41).
49