B Power Cord Set Requirements; 3-Conductor Power Cord Set; General Requirements - HP Compaq NC8000 Maintenance And Service Manual

Power Cord Set Requirements

3-Conductor Power Cord Set

The wide range input feature of the notebook permits it to operate
using any line voltage from 100 to 120 or 220 to 240 volts AC.
The power cord set shipped with the notebook meets the usage
requirements for the country where the equipment is purchased.
Power cord sets for use in other countries must meet the
requirements of these countries. For more information on power
cord set requirements, contact an HP authorized reseller or
service provider.

General Requirements

The requirements listed below are applicable to all countries:
■
The length of the power cord set must be at least 1.5 meters
(5.00 feet) and a maximum of 2.0 meters (6.50 feet).
■
All power cord sets must be approved by an acceptable
accredited agency responsible for evaluation in the country
where the power cord set will be used.
■
The power cord set must have a minimum current capacity of
10 amps and a nominal voltage rating of 125 or 250 volts AC,
as required by each country's power system.
■
The appliance coupler must meet the mechanical
configuration of an EN 60 320/IEC 320 Standard Sheet C13
connector for mating with the appliance inlet on the back of
the notebook.
Maintenance and Service Guide
B
B–1