Removal And Replacement Procedures - HP Compaq NC4010 Maintenance And Service Manual

5
Removal and Replacement
Procedures
This chapter provides removal and replacement procedures.
Torx and Phillips screws are removed during disassembly. There
are 57 screws, alignment pins, and standoffs, in 14 different sizes,
that must be removed, replaced, and/or loosened when servicing
the notebook. Make special note of each screw size and location
during removal and replacement.
Refer to Appendix C, "Screw Listing" for detailed information on
screw sizes, locations, and usage.
Maintenance and Service Guide 5–1