HP Compaq NC4010 Maintenance And Service Manual page 141

2. Turn the system board upside down with the rear panel facing
toward you.
3. Disconnect the modem board cable 1 from the modem
board.
4. Remove the two PM2.0×3.0 screws 2 that secure the modem
board to the system board.
5. Lift the rear edge of the modem board 3 to disconnect it from
the system board.
6. Remove the modem board.
7. If the modem board cable must be replaced, remove the
tape 4 that secures the cable to the system board and
disconnect the cable 5 from the system board.
Removing the Modem Board
Reverse the above procedure to install the modem board.
Maintenance and Service Guide
The modem cable is included with the modem board and is
also included in the Miscellaneous Plastics Kit, spare part
number 325528-001.
Removal and Replacement Procedures
5–61