HP 510 Maintenance And Service Manual page 54

17. Remove the display hinges (2).
NOTE
440707-001.
18. If it is necessary to replace the wireless antenna transceivers, remove the Phillips PM2.5×4.0
screws (1) that secure each transceiver (2) to the display enclosure.
NOTE
a thin layer of adhesive. It may be necessary to use a flat-bladed tool to pry the transceivers
away from the display enclosure.
19. Remove the wireless antenna transceivers (2) and cables (3) from the display enclosure.
NOTE
pliable tabs (4) built into the enclosure shielding. Lift the tabs to release the cables.
NOTE
Kit, spare part number 441639-001.
Reverse this procedure to reassemble and install the display assembly.
48 Chapter 5 Removal and replacement procedures
The display hinges are available in the Display Hinge Kit, spare part number
The wireless antenna transceivers are also attached to the display enclosure with
The wireless antenna cables are attached to the display enclosure by a series of
The wireless antenna transceivers and cables are available in the Wireless Antenna
ENWW