THOMSON DPL4000 - annexe 1 Instruction Manual

Speakers and Antenna
Speaker NOTE: For details, please refer to
Instruction manual chapter
"Connecting the Speakers"
• Match the speaker to the The color of speaker wires may
(Pg. 6)
correct terminal on the receiver vary. Please refer to the wires
(example: left speaker to left instruction book for details.
speaker terminal on receiver)
• Connect the red speaker wire
to the "+" terminal (both speaker
and receiver) and the black
speaker wire to the "-" terminal.
SPEAKER HOOK-UP
Follow the illustration and instructions provided to hook up
your speakers.
NOTE: Speakers and speaker cables are not provided.
Audio/Video components
Follow the diagram
to AUDIO IN (VCR)
to connect audio or
video components.
to VIDEO IN (VCR)
ANTENNA HOOK-UP
to VIDEO OUT
(VCR)
to AUDIO OUT (VCR)
Antenna Wire Connection
Cables
Push terminal tab down to
To help you identify the cables used in audio-video, illustrations are provided below for your easy reference.
insert wire.
RCA Audio cable Composite Video
(Analog) Cable (Usually yellow)
Release tab to lock wire in
the terminal.
NOTE: Make sure the
insulation is completely
removed from the ends of
the wire at all connection
points.
1 Piece 1Piece
Connection described below is also
applicable for any component having
digital output (Cable, Satellite, MD,
CDRW recorder, TV)
to S-VIDEO IN (TV)
(if available)
NOTE:
• By default, the unit is set to use
the Analog input from the DVD
to VIDEO IN (TV)
player.
to COMPONENT
VIDEO INPUT Follow the diagram to connect
(if available)
your DVD player to receiver.
to AUDIO OUT (TV)
1
or OPTICAL cable (not included)
2
3
(composite, s-video or component
video)
4
5
to select the input being used
(analog, coaxial, or optical) and
S-Video cable Optical Cable (Digital) Coaxial Cable release to validate.
(75 / Digital)
NOTE: To receive Dolby Digital /
DTS signal, either a coaxial or
optical cable must be connected;
and in step 5, you have to select
coaxial or optical input accordingly.
Not Included Not Included Not Included
DVD To A/V Receiver
• After the connections are done, • If a COAXIAL cable is used to
check the receiver and make sure it connect DVD to the receiver, follow
is set to the appropriate input. The steps 4 to 5 and select COAXIAL.
input being used will be displayed • S-Video connection provides better
after the source name. (DVD/OPT quality than composite connection.
means DVD uses Optical Input)
• To change input connection, follow
step 4 to 5 as described below.
Connect components capable of outputting digital signals like Dolby Digital (e.g.
DVD player or Satellite/Cable Box) or standard PCM format digital signals (CD
player). Read section on "Input Signal Setting" under "Advanced Sound Control"
carefully to adjust the matching input settings.
H O M E T H E A T E R A U D I O V I D E O R E C E I V E R D P L 4 0 0 0
VOLUME
DVD
ON/ECO
BAND TUNING MEMORY SETUP TEST TONE EQ DIGITAL INPUT
SOURCE OK SURR. MODE DSP MODE
ST/M
MUTE
BASS/TREBLE LEVEL
OPEN/CLOSE
L AUDIO R VIDEO S-VIDEO S-VIDEO VIDEO AUDIO OPTICAL
OUT COAXIAL
OUT OUT OUT
PHONES V-AUX
4
5
S-video to S-video out (DVD)
Connect either the COAXIAL
to VIDEO OUT (DVD)
3 2
Connect the RCA Audio cable.
to AUDIO OUT (DVD)
Connect the video cable
Select DVD
Press DIGITAL INPUT repeatedly
OUT COMPONENT OUT
to COMPONENT OUT(DVD)
(if available)
3
1