Page 1
We recommend that you have the plasma display professionally wall mounted. Make sure the wall where the plasma monitor is to be mounted is capable of supporting at least 4 times the weight of the monitor and wall mount assembly. If necessary, the wall must be reinforced.
Plasma mounting bracket screws (M8 x 20) - 6 Cardboard wall plate positioning template - 1 Important: Screws for installing the wall mount on the wall are NOT supplied. The type of screws to be used depends on the type of wall (wood, cement, etc.).
Installing the Mounting Brackets Carefully turn the plasma monitor over so that the back of it is facing you and place it on a soft and flat surface. Locate the mounting points on the back of the monitor (see figure 1).
Page 4
Locate and mark the dual 40 cm or 60 cm hole centres closest to the desired plasma placement area. Note: The wall mount plate provides you with three 40 cm hole patterns and one 60 cm hole pattern to assist you in your installation.
Page 5
(see figure 5). Secure the upper wall mount plate to the wall in the same manner as the lower plate using screws appropriate for this type of wall.
Notes: - When the monitor brackets hooks are fully installed into the upper and lower wall mount plate steel rods and the plasma is flat, there is a 22 mm gap from the top of the rod to the end of the hook. This is to compensate for tilting.