Canon Creative Park Merry-go-round picture castle Assembly Instructions Manual

Merry-go-round picture castle : Assembly Instructions
Assembly tip
Writing the number of each section on its back side before cutting out the sections is highly recommended.
(* This way, you can be sure which section is which even after cutting out the sections.)
Fold and crease mountain folds and valley folds before applying glue.
Take your time to cut out each piece carefully.
Trace along the folds with a ruler and an exhausted pen (no ink) to get a sharper, easier fold.
When applying glue to large areas,
take care to prevent warping of paper that may be caused by over-application of glue.
Apply small amounts of glue around the peripheral of the piece or use dual-sided tape to minimize warping.
Necessary utensils
Scissors, set square, glue, pencil, used ballpoint pen
Caution
Please read the Assembly Instructions carefully,
and assemble in order as shown on the pattern sheets.
This papercraft involves using glue, scissors,
and other utensils and materials that may be dangerous
to young children.
Please work somewhere out of reach of young children.
Assembly Instructions
Three A4 sheets (No. 1 to No. 3)
Notation Key
Mountain fold
(dotted line)
Valley fold
(dashed and dotted line)
Scissors line (solid line)
Guidelines (dotted lines)
Align these guidelines
when gluing pieces together.
Arrow indicates Glue spot (Red dot)
position for gluing
or insertion. Glue reverse side
(Green dot)
The following are used in the assembly instructions.
Indicates reverse side of paper.
Indicates front/reverse of sections to be glued.
Glue the same numbers to each other.
Prepare the materials.
Main materials for the castle
Cut out the parts, and fold them in advance.
For the 4 regular polygons, cut off the outline, give mountain
folding and cut out the part indicated with
How to build the center of the castle
.
Glue and insert the parts in the order
of the numbers.