2. Loosen the screws on the front cover of the Safety Switch , as shown below:
3. Remove the Safety Switch cover.
4. Open the required AC and DC conduit drill guides according to the conduits used in the installation:
The drill guides are located at the bottom and sides of the enclosure, each with two sizes: ¾'' and 1''.
Open the required drill guides, taking care not to interfere with any of the internal components. It is
recommended to use a Unibit drill.
NOTE
Unused conduit openings and glands should be sealed with appropriate seals.
Mounting the Inverter
The mounting brackets kit includes the following parts:
Two brackets for mounting on a wall/ pole (screws not included)
l
Two screws with washers for fastening the inverter brackets to the wall brackets.
l
Single Phase Inverter with HD-Wave Technology Installation MAN-01-00306-1.1
Figure 11: Opening the Safety Switch cover
Figure 12: Safety Switch drill guides
Figure 13: Mounting brackets and screws
Chapter 3: Installing the Inverter
25