Table of Contents
Advertisement
2.11 INFORMATION MENU
By pressing the button "
To scroll through the various parameters, press the buttons "DHW regulation" "
With the menu active on the indicator 19, Fig. 48) the parameter via the letter "d" plus the number of the parameter that is being displayed
will alternately show.
To view the parameter value, select it by pressing the button
Press "
" or wait 15 minutes to go back to the previous screen or exit the menu.
Parameter ID
d 0.0
Not used
d 0.1
Displays the flame signal
d 0.2
Displays the primary heat exchanger outlet instant CH flow temperature (°C)
d 0.3
Displays the instant output temperature from the DHW exchanger
d 0.4
Displays the values set for central heating set
d 0.5
Displays the values set for DHW set
d 0.6
Not used
d 0.7
Displays the temperature of the inlet DHW (°C) (with optional DHW inlet probe present)
d 0.8
Displays the system return water temperature (°C)
d 0.9
Displays the list of the last eight faults (to scroll the list press the "central heating temperature regulation" buttons (6 and 7)).
Anomaly list reset. Once "d 10" is displayed, press Stand-by; the display shows "--". Then press the Stand-by key again for at least 3
d 1.0
seconds; deletion is confirmed via the "88" symbols flashing for two seconds.
d 1.1
Not used
d 1.2
Displays the pump operating speed
d 1.3
Not used
d 1.4
Displays the pump flow rate (l/h)
d 1.5
Displays the fan operating speed (rpm)
d 1.6
Displays the temperature read on the flue probe (°C)
d 1.7
Displays the calculated flow temperature (°C)
d 1.8
At the end of the screed heater function, displays for how many hours the flow temperature remained at "Top set"
d 1.9
Toggles between the safety software version and the functional software version
d 2.0
Not used
d 2.1
Not used
d 2.2
Not used
68
", the "Information" menu is activated for at least 1 second, displaying some system operating parameters.
".
.
Description
Advertisement
Table of Contents
