Table of Contents
Advertisement
Victrix Hybrid Electrical connection diagram.
Key (Fig. 12):
A23 - Outdoor Unit Audax.DK4
A33 - Victrix Hybrid Plus control panel
B2
- Storage tank probe (optional - not available for this model)
B9
- DHW inlet probe (optional - not available for this model)
A 230VAC (optional) room thermostat can be connected on terminals 1 and 2 of the terminal block present in the indoor unit. For the
connection, see 1.16.
To connect the Audax.DK4 outdoor unit to the control panel, connect the communication cables from terminals "D+ - D-" of the outdoor
unit to terminals "5 - 6 "of the control panel. Consult the relative instructions manual to access the electrical connections of the outdoor
unit.
To connect the communication BUS of the outdoor unit to the control panel, connect the communication cables from terminals "44 - 41"
of the indoor unit to terminals "1 - 2" of the control panel.
For low voltage power supply of the control panel, connect the communication cables from terminals "24-25" present on the terminal
block of the indoor unit to terminals "7-8" of the control panel.
To connect the optional DHW input probe, connect the cables to terminals "38 - 48" on the terminal board of the indoor unit.
1.13 CONTROL PANEL MAIN DIMENSIONS
X
- Power supply
Y
- Configurable relay
Z
- Configurable output
12
13
25
Advertisement
Table of Contents
