SolarEdge Home Hub Quick Installation Manual

SolarEdge
Home Hub Inverter -
Three Phase
Quick Installation Guide
V1.1
What's in the Package
Inverter
Wall mount
DC connection
bracket
box
WARNING!
This symbol denotes a hazard. The symbol calls attention to a procedure that could result in injury or loss
of life if not correctly performed or adhered to. Do not proceed beyond a warning note until the
conditions are fully understood and met.
CAUTION! Denotes a hazard. The symbol calls attention to a procedure that could result in damage or
destruction of the product if not correctly performed or adhered to. Do not proceed beyond a caution sign until
the indicated conditions are fully understood and met.
Backup System Installation
IMPORTANT NOTE! When installing or upgrading your backup system:
1. First, install the Inverter.
2. Next, install the Battery.
3. Finally, if applicable, install the Backup Interface (BUI).
Mounting
A
CAUTION! DO NOT rest
the inverter vertically on
the connectors
4
3
4 N*m
5
CAUTION! Do not
block airflow
SolarEdge Home Antenna Ferrite
Cable lugs
Network Antenna bracket Bead
10 cm
10 cm
Optional antenna location
37 KG
2
Optional
1
6
4
1
7 10
5 6
9
8
3
2
solaredge.com
SolarEdge Technologies GmbH, Werner-Eckert-Str. 6, 81829 Munich, Germany
Subject to change without notice.
© SolarEdge Technologies, Ltd.
All rights reserved. February 2024.
Unpacking and
Mounting Video
Compact guide,
warranty card, and
specification sheet
Wiring
B
WARNING!
POWER AND WAIT FOR 5 MINUTES BEFORE INSTALLATION OR
SERVICE
WARNING!
the Safety and Handling instructions provided with this product.
2
WARNING! Connect a
ground cable according
to local regulation.
Wiring Video Datasheet
Tools and Materials
Drill Pencil Level
Open-end Torque wrench
with 10 mm socket hex
torque
wrench and 5 mm Allen bit
Phillips/Flat-Blade
Small Flat-Blade Mounting screws and
screwdriver set
Screwdriver wall plugs - max M10
HAZARD OF ELECTRIC SHOCK. DISCONNECT
Before installing or operating the Inverter, read
WARNING! connect the grounding wire first
Ferrule
AC
(For stranded wires
4
L1 L2 L3 N
1.5 N*m
1
3
OFF
5
CAUTION! DO NOT
DC
use a circuit breaker
with a rated current
of more than 20A
PV String(s)
Installation Guide
Crimping tool
Wire Cutter
Hammer
min 2
Manual Shutdown
Switch
)
2.5-16 mm
2
8 mm
15-21 mm