HP Envy 17-da0 Series Maintenance And Service Manual page 51

1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the solid-state drive (see
5. Remove the memory modules (see
6. Remove the WLAN module (see
NOTE: You do not have to remove the heat sink before you remove the system board.
Remove the system board:
1. Disconnect the following cables from the system board:
● IR board cable (ZIF) (1)
● Display cable (ZIF) (2)
● Speaker cable (3)
● Touchpad cable (ZIF) (4)
● Backlight cable (ZIF) (5)
● Keyboard cable (ZIF) (6)
● Antenna cables from the WLAN module (7)
● USB/audio board cable (8)
● Speaker cable (9)
● Camera cable (ZIF) (10)
Preparation for disassembly on page
Bottom cover on page
Battery on page 31).
Solid-state drive on page
Memory modules on page
WLAN module on page
29).
32).
34).
36).
29).
System board 45