Immergas VICTRIX HYBRID PLUS Manual page 92

Menu item
O.U. Heating req.
O.U. DHW req.
O.U.operational
O.U. startup time
Defrosting
O.U. in antifreeze
Cool start
O.U. exchanger preheat.
O.U. fault level
O.U. fault status
Menu item
Pump speed Circulator speed status
Pump flow rate Indicates circulation inside the hydraulic circulator
DHW 3-way DHW three-way status
Calc. system temp. set Flow set point determined by temperature control
O.U. max calculated set Maximum flow set point calculated for the outdoor unit
System Status Immergas after sales service diagnostic value
Heater Status Immergas after sales service diagnostic value
Menu item
Pump down Function for gas removal on water/gas heat exchanger
Heater kit test UE anti-freeze resistance kit control outlet forcing
Pump flow rate Indicates circulation inside the hydraulic circulator
92
"Service" -> "Generator info" -> "O.U. Status" menu
Indicates the presence of a heating demand to the U.E.
Indicates the presence of a DHW demand to the U.E.
Indicates that the heat pump is available
Time elapsed since the U.E. start-up request
Indicates that the defrosting of the outdoor unit is in progress
Indicates that the heat pump is performing an antifreeze function
Indicates the machine was cold started
Not used on this model
It identifies the presence of alterations to operation of the O.U.
Indicates whether the O.U. is stopped due to an anomaly
"Service" -> "Generator info" -> "System State" menu
Description
"Service" -> "Maintenance" menu
Description
Description
Range Default
0 - 100 %
0 - 2000 l/h
(reading only)
DHW / Heat /
Mix
Range Default
Off / On
Off / On
0 - 2000 l/h (only
reading)
Customised
value
Customised
value