Table of Contents
Advertisement
Id
Parameter
Parameter
Central heating
set point
t0
minimum
temperature
Central heating
set point
t1
maximum
temperature
t2
-
D.H.W. priority
t3
timing
Central heating
t4
ignitions timer
Heating ramp
t5
timing
CH ignition
t6
delay from TA
and CR request
t7
Display lighting
t8
Display
Flow off
t9
temperature
increase
100
Description
Set this parameter from the control panel. see Par. 3.6
Set this parameter from the control panel. see Par. 3.6
Not available for this model
Set this parameter from the control panel. see Par. 3.6 (when
combined with a storage tank unit)
Set this parameter from the control panel. see Par. 3.6
Set this parameter from the control panel. see Par. 3.6
Set this parameter from the control panel. see Par. 3.6
Establishes the display lighting mode.
0: the display lights up during use and lowers after 15 seconds
of inactivity. In the case of anomaly the display flashes.
1: display lighting off.
2: the display is always lit up.
Establishes what the indicator displays 19 (Fig. 49).
"Summer" mode:
0: the indicator is always off
1: pump active displays the flow temperature, pump off the
indicator is off
"Winter" mode:
0: it always displays the value set on the central heating
selector
1: circulator pump active displays the flow temperature,
pump off displays the value set on the central heating
selector
Increases the flow off temperature at ignition only in the first
60 seconds. After the flame is detected, the temperature is
increased by t9
Range
Default
-
-
0 - 2
0
0 - 1
1
0 - 15
0
Customised
value
-
Advertisement
Table of Contents
