Table of Contents
Advertisement
Installing the Wired remote controller (Continued)
Installation
1
Open the wired remote controller by pushing up the top cover of the remote controller while
holding the rear cover firmly. The wired remote controller opens in the way of slide.
2
Install the rear cover of the wired remote controller on the wall with the supplied screws. After
that, arrange the power cables on rear side of the front cover.
3
Connect the yellow and orange wires from the wired remote controller to the power cable
(V1, V2) of indoor unit. Connect the red and blue wires to the communication cable (F3, F4) of
indoor unit.
Connector type cable connection
Tighten the
F3
F4
cable with the
wire joint
Housing
(accessories)
tightly.
Communication
cable(F3, F4)
4
Reassemble the wired remote controller.
When you reassemble the wired remote controller, match the grooves on the left side.
When using an extension cable, make sure that the communication cable and the
power cable is installed separately.
(If not, it may cause malfunction of the wired remote controller.)
Power cable of the wired remote controller(V1,V2) should be connected to the one
indoor unit only.
6
E-
More than
More than
60mm
30mm
Screw hole
Rear cover
Before fixing the rear cover, clear
30mm of space on the top and
60mm on the right side.
Power cable
(V1, V2)
Indoor unit
Multi function
wired remote
controller
Fasten the screw in the screw hole.
Terminal type cable connection
Power cable
Communication
(V1, V2)
cable(F3, F4)
Indoor unit
Front cover
Multi function
wired remote
controller
Advertisement
Table of Contents
