Pre-Season Check - BRP EVINRUDE E15R4 Operator's Manual

76
INSPECTION AND MAINTENANCE
1. Disconnect the fuel hose from the out-
board motor.
2. Remove the top cowl.
3. Place an approved fuel container
under the drain screw and use a funnel
to avoid spilling fuel.
4. Loosen the carburetor drain screw.
5. Tilt up the outboard motor until fuel
flows out of the drain hole.
6. Leave the outboard motor in this posi-
tion until all fuel has been drained.
7. When thoroughly drained, retighten the
drain screw securely.
8. Check the drained fuel for the pres-
ence of water or other contaminants. If
either is present, reassemble the out-
board motor, refill the carburetor with
fuel, and then drain the fuel again.
Repeat this procedure until no water or
other contaminants are present in the
drained fuel.
10
1. Carburetor drain screw
ENOM00102-0
Battery
ENOW00931-A
 Place the battery away from any source
of fire, sparks and open flames such as
burners or welding equipment.
 Place the battery away from fuel tank.
Accidental sparks of battery may cause
explosion of gasoline.
1. Disconnect the battery cables and be
sure to remove the negative terminal
first.
2. Wipe off any chemical deposits, dirt, or
grease.
3. Apply grease to the battery terminals.
4. Charge the battery completely before
storing it for the winter.
5. Recharge the battery once a month to
prevent it from discharging and the
electrolyte from deteriorating.
6. Store the battery in a dry place.
ENOM00104-A

4. Pre-season check

The following steps must be taken when
first using the engine after winter storage.
1. Check that the shift and throttle func-
tion properly. (Be sure to turn the pro-
peller shaft when checking the shift
function or else the shift linkage may
1
be damaged.)
2. Check the electrolyte level, and mea-
ENOF01233-0
sure the voltage and specific gravity of
the battery.
Specific Gravity
at 20°
1.120
1.160
WARNING
Terminal Voltage
Charge Condition
(V)
10.5 Fully discharged
11.1 1/4 charged