Table of Contents
Advertisement
34
ENGINE OPERATION
And be sure to remove the propeller, when
starting the engine in the test tank. (See
page 68)
Run the engine only at idling.
1
1. Over 10 cm (4 in.)
ENOW00036-0
7
Be sure to stop engine immediately if cool-
ing water check port is not discharging
water, and check if cooling water intake is
blocked. Operating engine could lead to
overheating potentially leading to engine
damage. Consult an authorized dealer if
the cause cannot be found.
ENOW00032-A
Do not keep turning starter motor for over
5 seconds, or the battery may be con-
sumed, potentially making the engine start-
i n g i m p o s s i b l e a n d / o r d a m a g i n g t h e
starter.
If cranking over 5 seconds fails to start
engine, return main switch to "ON", and
crank engine again after 10 seconds or
more.
Do n o t t ry t o c ra nk a f t e r e n gin e h as
started.
This model is provided with start in gear
protection.
ENOF00863-0
CAUTION
CAUTION
ENON00010-0
Note
Start-in-gear protection prevents engine
from starting at other than neutral shift. In-
gear starting of engine will move the boat
immediately, potentially leading to falling
down or causing passenger(s) to be thrown
overboard.
Tiller handle type
1. Be sure to install the stop switch lock
to the stop switch, and attach the stop
switch lanyard securely to the operator
or to the operator's PFD (Personal Flo-
tation Device.)
1
1. Stop switch lock
2. Set the control lever in the Neutral
position.
R
1. Shift lever
ENOF00310-A
N
1
F
ENOF01210-0
Advertisement
Table of Contents
