Engine Operation; Before Starting; Fuel Feeding - BRP EVINRUDE E15R4 Operator's Manual

32

ENGINE OPERATION

ENOM00042-0

Before starting

ENOW00022-A
The engine oil is drained for shipping from
the factory. Be sure to fill the engine to the
proper level before starting engine. (To
properly fill the engine with oil follow the
instructions. See page 58)
7
ENOW00027-A
Before starting engine for the first time
after reassembling engine or off-season
storage, disconnect stop switch lock and
crank approximately 10 times in order to
prime the oil pump.
ENOM00044-A

1. Fuel feeding

ENOW00029-A
When opening fuel tank cap, be sure to fol-
low the procedure described below. Fuel
could blast out through the fuel tank cap in
CAUTION
ENOF01209-0
CAUTION
WARNING
case the cap is loosened by using another
procedure when internal pressure of fuel
tank is raised by heat from sources such as
sun light.
ENOW00030-B
WARNING
When using EPA approval fuel tank, only
use a primer bulb/hose assembly that has
a Fuel Demand Valve (FDV) installed in the
fuel hose or a sealing mechanism in the
fuel connector as shown below.
FDV and fuel connector that has an sealing
mechanism prevent pressurized fuel spill-
age when the fuel connector is connected
to the engine.
1
1. FDV in fuel hose
2. Sealing mechanism in fuel connector
3. Identification
Do NOT use a primer bulb/hose assembly
that does not contain a Fuel Demand Valve
or a sealing mechanism as shown below:
otherwise fuel spillage may occur when the
connector is connected to the engine.
Do not connect fuel connector except
when operating engine. Fuel leakage is a
fire or explosion hazard, which can cause
serious injury or death.
2
3
ENOF00035-0
ENOF00036-0