Removal And Replacement Procedures For Authorized Service Providers; Component Replacement Procedures; Preparation For Disassembly; Computer Feet And Bottom Cover - HP Chromebook x360 14 G1 Maintenance And Service Manual

5 Removal and replacement procedures for
authorized service providers
CAUTION:
Accessing these parts can damage the computer or void the warranty.
NOTE: HP continually improves and changes product parts. For complete and current information on
supported parts this your computer, go to http://partsurfer.hp.com, select your country or region, and then
follow the on-screen instructions.

Component replacement procedures

There are as many as 40 screws that must be removed, replaced, and/or loosened when servicing
the computer. Make special note of each screw size and location during removal and replacement.

Preparation for disassembly

See Removal and replacement procedures preliminary requirements on page 15
1. Turn off the computer. If you are unsure whether the computer is off or in Sleep state, turn the computer
on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer

Computer feet and bottom cover

Table 5-1 Computer feet and bottom cover descriptions and part numbers
Description
Computer feet (included in the rubber kit)
Bottom cover
Remove the computer feet and bottom cover:
1. Prepare the computer for disassembly
2. Close the computer and position it upside down.
3. Peel the two rubber feet off the computer (1).
4. Remove the five Phillips M2.5 × 8.0 screws (2) from under the feet.
20 Chapter 5 Removal and replacement procedures for authorized service providers
Components described in this chapter should only be accessed by an authorized service provider.
(Preparation for disassembly on page
for initial safety procedures.
Spare part number
L50835-001
L50830-001
20).