GE 600 Series Owner's Manual page 6

IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE
WARNING
OVEN SAFETY INSTRUCTIONS
door. Hot air or steam which escapes can cause
a glowing spot during use or shows other signs
of damage. A glowing spot indicates the heating
element may fail and present a potential burn, fire,
or shock hazard. Turn the oven off immediately and
have the heating element replaced by a qualified
service technician.
stones, or any type of foil or liner on the oven floor.
These items can trap heat or melt, resulting in
damage to the product and risk of shock, smoke or
fire.
careful to avoid touching hot surfaces and do not
let pot holders contact any hot heating element in
oven.
WARNING
REMOTE ENABLE EQUIPMENT (On some models)
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation. The wireless communication
equipment installed on this range has been tested and
device, pursuant to part 15 of the FCC Rules.
These limits are designed to:
(a) provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
harmful interference to radio or television reception,
READ AND SAVE THESE INSTRUCTIONS
6
an oven can ignite.
burns.
the oven may ignite.
follow the manufacturer's directions.
SHOCK OR BURN HAZARD:
oven light bulb, disconnect the electrical power to
the oven at the main fuse or circuit breaker panel.
Failure to do so may result in electric shock or burn.
CAUTION
BURN HAZARD: The glass cover
and bulb should be removed when cool. Touching
hot glass with bare hands or a damp cloth can
cause burns.
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
receiver.
circuit different from that to which the receiver is
connected.
technician for help.
(b) accept any interference received, including
interference that may cause undesired operation of
the device. Note that any changes or modifications
to the wireless communication device installed on
this oven that are not expressly approved by the
manufacturer could void the user's authority to operate
the equipment.
49-2001192 Rev. 0