Single phase inverter with prism technology (68 pages)
Summary of Contents for SolarEdge 330kW
Page 1
Version 1.0, December 2023 SolarEdge 330kW inverter internal fan for short bracket replacement – Support kit manual This manual describes the procedure for replacing the SolarEdge 330kW Inverter Internal Fan for Short Bracket. Revision history Version 1.0, December 2023 – Initial release Kit contents SolarEdge 330kW Inverter Internal Fan for Short Bracket PN FLD-3PH-OR-IN-01.
Page 2
Remove the cover NOTE The inverter cover assembly is too big for one person to handle safely. SolarEdge recommends that two people remove and handle the cover assembly. To remove the inverter cover, use a screwdriver with a 5mm hex bit to release the screws holding the cover in place.
Page 3
When installing the fan and bracket, the bracket must not touch the bus bar. 4. Using a flat screwdriver, tighten the fan assembly clamping screws to a torque of 2.4N·m (21.2lbf·in). SolarEdge 330kW inverter internal fan for short bracket replacement - Support kit manual...
Page 4
1. Unlock the power distribution panel and turn ON the AC circuit breaker/s. 1. Remove the padlock and turn the DC Switch ON. 2. Set the P/1/0 switch to “1” (ON). SolarEdge 330kW inverter internal fan for short bracket replacement - Support kit manual...