Install The Rangetop Backsplash Accessory - GE Monogram ZGU484NGP5SS Installation Instructions Manual

ZX12B30PSS, ZX12B36PSS, ZX12B48PSS Accessory Installation
OPTIONAL ACCESSORIES—12" HIGH BACKSPLASH
A WARNING:
To prevent ignition of combustible materials,
the entire back wall above the range must
be protected by a backsplash constructed
of non-combustible material.
This stainless steel backsplash accessory
must be installed in combination with a custom,
non-combustible backsplash built beyond
the 12" height of the backsplash.
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
IMPORTANT: Save these instructions for local
inspector's use.
IMPORTANT: OBSERVE ALL GOVERNING CODES
AND ORDINANCES.
NOTE TO INSTALLER: Be sure to leave these
instructions with the Consumer.
NOTE TO CONSUMER: Keep these instructions
with your Owner's Manual for future reference.
This kit provides for the installation of a 12"
high backsplash for 30", 36" or 48" Monogram
Professional Ranges and Rangetops.
TOOLS AND MATERIALS REQUIRED
eGloves to protect against sharp edges
eT-15 and #2 Phillips screwdrivers
e Drill with 3/32" and 9/64" bits
eSafety glasses
e Level
ePencil
This Kit Includes
eWall support panel
eCover panel
e Hardware package with
- 5 Stainless Steel Torx 15 #8 '
ee
Wall Support
Panel
Cover Panel
self-tapping Screws Hardware
- 5 Phillips #2 pan head wood Package
#10 screws
12
INSTALL 12" BACKSPLASH
A WARNING: this backsplash must
be securely fastened to the wall. Failure to do
so could result in damage or personal injury.
e|nstall and level the range or rangetop and the range
hood according to the installation instructions.
e Remove the backsplash packaging and
protective film.
¢ Use a level to pencil a horizontal line on the wall, 1/8"
above the range or rangetop. The 1/8" gap allows
the cover panel to overlap the wall support panel.
«Locate wall studs on each side. Where studs are not
available, plan to use wall anchors (not provided).
e Align the wall support panel on the marked
horizontal line and centered left to right.
e The wall support panel must be secured to the wall
at all 4 corners. Use wood screws (provided) or wall
anchors (not provided) to secure the support panel
to the wall.
e Place the cover panel over the wall support
panel and secure with Torx screws (provided).
Install 2 screws on each side.
Install 4
Wood Screws
<—— Wall Support
Panel
1/8" +
ne aw Screws
Wall
Support
Panel