Table of Contents
Advertisement
Operation with zone card connected on DimBUS
By connecting the zone card (optional) to DimBus, the flow temperature settings of the three zones can be set by pressing the CH buttons
+/- (7-8).
The display will then show the setting of the first zone (u1) and you can change its value by pressing the CH +/- buttons (7-8).
+
-
RESET
INFO
+
-
RESET
INFO
68
+
-
MODE
49
+
-
MODE
50
If the optional outside sensor is present, the flow temperature cal-
culation curve is set depending on the outside temperature (Par-
ag. 1.11).
Confirming the value with MODE will display the setting of the
second zone (u2), which can be changed in the same way by subse-
quently accessing the third zone (u3).
When the third zone mode is over, the display will return to the
standard display.
Advertisement
Table of Contents
