Table of Contents
Advertisement
1.22 CONFIGURATION C
This configuration (allowed only with the approved original flue, including the specific non-return valve), makes it possible to suck the
air outside the home or directly from the shaft where the flue gas exhaust is present and the evacuation of the flue gas itself inside a collec-
tive flue.
C
(Fig. 35):
10
Coupling to the shaft for intake is possible with male flue Ø 80 or Ø 80 cut female.
C
- C
(Fig. 35 - 36)
10
12
The collective flue coupling for the exhaust is possible with female Ø 80 flue with gasket.
Assembly of separator kit Ø 80/80 (Fig. 37):
1. Install the discharge flange (4) on the appliance sample point flange, positioning the relative gasket (1) with the circular projections
downwards in contact with the appliance flange, and tighten using the hex screws with flat tip contained in the kit.
2. Remove the flat flange present in the intake hole and replace it with the intake flange (3), positioning the gasket (2) contained in the
separator kit Ø 80/80 and tighten using the supplied self-threading screws.
3. Eliminate the extension Ø 125 from the non-return valve kit on the flue gas.
4. Insert the spacer Ø 80 th. 5 mm into the flue exhaust flange.
5. Insert the flue gas non-return valve on the Ø 80 flues inside the flue exhaust flange.
46
- C
SEPARATOR KIT (Ø 80/80)
10
12
C
10
35
C
12
36
Advertisement
Table of Contents
