SolarEdge SE8000H-AU Installation Manual page 67

Replacing an Inverter
6. Remove the screws securing the inverter to the mounting brackets and lift the inverter from the
mounting bracket.
NOTE
If you remove the old inverter and do not immediately install a new one, use insulation tape to isolate
each of the AC and DC wires
7. Place the new inverter on the mounting brackets and secure it using the screws.
8. Reconnect the cables: Follow the instructions of Installing the Inverter on page 19.
9. Close the inverter cover.
10. Perform the commissioning steps as described in Commissioning the Installation on page 25.
66
Single Phase Inverter with HD-Wave Technology Installation MAN-01-250-1.2
Figure 29: Mounting brackets