Creating An Ethernet (Lan) Connection - SolarEdge SE8000H-AU Installation Manual

4. Open the inverter cover (see Figure 16):
a. Release the s ix Allen screws of the cover.
b. Tilt the top of the cover towards you.
c. Slide the cover down and remove it.
CAUTION!
When removing the cover, make sure not to damage the internal components. SolarEdge will not be held
responsible for any components damaged as a result of incautious cover removal.

Creating an Ethernet (LAN) Connection

This communication option enables using an Ethernet connection to connect the inverter to the
monitoring platform through a LAN.
Ethernet cable specifications:
Cable type – a shielded Ethernet cable (Cat5/5E STP) may be used
l
Maximum distance between the inverter and the router – 100 m/ 330 ft.
l
Single Phase Inverter with HD-Wave Technology Installation MAN-01-250-1.2
Figure 16: Removing the Inverter Cover
Figure 17: Example of Ethernet connection
Chapter 6: Setting Up Communication
47