Gsm Status; Communication Ports Status - SolarEdge SE8000H-AU Installation Manual

Single phase inverter with hd-wave technology
Table of Contents

Advertisement

GSM Status
GSM Status
If a GSM Plug-in is connected, this screen replaces the Server status screen:
S e r v e r : C e l l
S t a t u s :
M N O :
< x x x x x x x >
< E r r o r
Server: The method of communication to the SolarEdge monitoring platform. Should display Cell.
l
Status: Displays OK if the inverter established a successful physical connection to the modem.
l
S_OK: The last communication to the SolarEdge monitoring platform was successful (appears if the 
l
inverter is connected to the platform). If S_OK is not displayed, refer to Status Screens - Operational 
Mode on page 38.
MNO: The mobile network operator name
l
Sig: The signal strength, received from the modem. A value between 0-5, (0 = no signal; 
l
5 = excellent signal)
Error message: per communication connection status failure
l

Communication Ports Status

R S 4 8 5 - 1 < S E > < S
Z i g B e e
##: The total number of slaves detected on the specific port
l
Dev: The type of device that was configured to a specific port (based on the port's functionality), as 
l
follows:
 
SE: SolarEdge device (default)
o
 
LGR: Non-SolarEdge logger
o
 
MLT: Multiple devices, such as meters and batteries
o
 
HA: Home automation devices (for Smart Energy)
o
PROT: The protocol type to which the port is set:
l
 
For a SolarEdge device:
o
RS485 protocol
 
For electricity meters,   r efer to the application note - Connecting an Electricity Meter
o
to SolarEdge Devices at http://www.solaredge.com/files/pdfs/solaredge-meter-
installation-guide.pdf.
 
SS: SunSpec - for a non-SolarEdge logger (monitoring and control)
o
42
Single Phase Inverter with HD-Wave Technology Installation MAN-01-250-1.2
< S _ O K >
< O K >
S i g : 5
m e s s a g e >
D e v
P r o t
# #
>
< - - >
< S E > < M P S > < - - >
S: SolarEdge slave
M: SolarEdge master
ZigBee protocol
P2P: ZigBee point-to-point
MPM: ZigBee multipoint master (for the ZigBee gateway or
for load management by the inverter)
MPS: ZigBee multipoint slave (for a ZigBee router card)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Se3000h-auSe2500h-au

Table of Contents