Zigbee Status; Wi-Fi Status - SolarEdge SE8000H-AU Installation Manual

ZigBee Status

This screen describes the ZigBee configuration:
P A N : X X X X X
C H : X X / X X X X
M I D : X X X X
RSSI: The receive signal strength indication of the closest ZigBee in the system. L = low, M = medium, H
l
= high and (-) = no signal.
PAN ID: The ZigBee transceiver PAN ID (Personal Area Network Identification), the ID uniquely
l
represents a device in a Zigbee network.
Ch.: The ZigBee transceiver channel
l
ID: The ZigBee transceiver ID
l
MID: The Master ID of the coordinator (master) ZigBee Plug-in. This field is shown only in devices with
l
router (slave) ZigBee cards, and after a successful ZigBee association. If a ZigBee Plug-in is not
connected, a No ZigBee message is displayed instead of the MID field.

Wi-Fi Status

This screen describes the Wi-Fi configuration:
I P : 1 9 2 . 1 6 8 . 2 . 1 1 9
G W : 1 9 2 . 1 6 8 . 2 . 1
S S I D : x x x x x x x x
R S S I : < L / M / H / - >
IP: The DHCP provided address
l
GW: The gateway IP address
l
SSID: Service Set Identifier - the name of a wireless local area network (WLAN). All wireless devices on a
l
WLAN must employ the same SSID in order to communicate with each other.
RSSI: The receive signal strength indication of the closest Wi-Fi in the SolarEdge system. L = low, M =
l
medium, H = high and - = no signal.
Single Phase Inverter with HD-Wave Technology Installation MAN-01-250-1.2
R S S I : < L >
X X
Chapter 5: Configuring the Inverter
41