Mounting The Inverter - SolarEdge SE8000H-AU Installation Manual

Mounting the Inverter

Drain valve: Drains any moisture that may be accumulated in the unit.
l
LCD panel: Displays inverter information and configuration parameters
l
LCD LEDs: Three LEDs located to the right of the LCD indicate the following inverter statuses:
l
Color Description
Green Power production
Communication and
Yellow
inverter shutdown
Red
All LEDs turn on while the inverter is being configured.
Mounting the Inverter
The mounting brackets kit includes the following parts:
Two brackets for mounting on a wall/ pole (screws not included)
l
Two screws with washers for fastening the inverter brackets to the wall brackets.
l
NOTE
Make sure the mounting surface or structure can support the weight of the inverter.
CAUTION!
SolarEdge inverters can be installed at a minimum distance of 50 m/ 164 ft from the shoreline of an
ocean or other saline environment, as long as there are no direct salt water splashes on the inverter.
1. Determine the inverter mounting location, on a wall, stud framing or pole. I t is recommended to
mount the inverter in a location protected from direct sunlight.
2. To allow proper heat dissipation, maintain the following minimum clearance areas between the
inverter and other objects:
20
Single Phase Inverter with HD-Wave Technology Installation MAN-01-250-1.2
On - The inverter is producing power.
Blinking - Standby mode. The inverter is in Standby mode until its
working voltage is reached. The inverter then enters Production
mode and produces power.
Off - The inverter is not producing power. This may be during Night
mode, when the inverter ON/OFF switch is OFF or when an error
occurs.
Blinking:
Monitoring information is being received from a power
o
optimizer.
The inverter is being shut down.
o
On - There is an error. Refer to Errors and Troubleshooting on page
Fault 54 for more information.
Blinking - The inverter is being shut down.
Figure 6: Mounting brackets and screws
Functionality