Table of Contents
Advertisement
2.
Pry the two rear rubber feet off the top cover.
3.
Remove the 12 Phillips PM2.5×6.0 screws (1) that secure the top cover to the computer.
4.
Separate the top cover from the computer by lifting up on the front of the top cover (starting near the
touchpad) (1), and then lifting the cover up and off the computer (2) far enough to access the keyboard
and touchpad cables on the system board.
NOTE:
When you lift the top cover, cables are connected from the keyboard and touchpad (installed
on the inside of the top cover) to the system board. Be sure not to pull the cables loose when lifting the
top cover.
Component replacement procedures
29
Advertisement
Table of Contents
