5.
To remove only the USB/audio cable, disconnect the cable from the ZIF connector on the USB/audio
board (1) and system board (2), and then peel the cable (3) off the computer. The cable is secured
with adhesive.
To install the USB/audio board, reverse this procedure.
Solid-state drive
To remove the M.2 solid-state drive, use this procedure and illustration.
Table 5-5
Solid-state drive descriptions and part numbers
Description
1 TB
512 GB
Solid-state drive cover
Before removing the solid-state drive, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
Remove the solid-state drive:
1.
Remove the two Phillips M2.0 × 2.0 screws (1) that secures the bracket.
Preparation for disassembly on page
Bottom cover on page
29).
Spare part number
N45474-005
N45476-005
N59286-001
Battery on page
30).
Solid-state drive
29).
35