TP-Link KE100 Quick Start Manual

Quick Start Guide
Smart Thermostatic Radiator Valve
Install Guide:
Scan QR code or visit
https://www.tp-link.com/support/faq/3404/
7106510498 REV1.2.1 *Images may differ from your actual product.
1. Unscrew the existing valve.
2. Check your connector type. The ▲ at the bottom of the
valve indicates the position of the display.
For M30 x 1.5 connector: Screw the new valve directly.
1.5mm
M30 x 1.5
30mm
If you want to remotely control / manage the valve, you need to add a Kasa smart hub first.
1. Set up a Kasa smart hub in the Kasa Smart app if you
haven't already done so. You can get the Kasa Smart app
from the App Store or Google Play.
OR
1. Check existing valve type
There are two types of valves: Thermostatic and Manual.
Kasa Smart Thermostatic Radiator Valve is only compatible
with the thermostatic valve.
Thermostatic Valve Manual Valve
02 / Install the Valve
For non-M30 x 1.5 connector: Check whether one of the provided adapters fits the connector. If not, please purchase a proper
one yourself.
RAVL Adapter
RAV Adapter
03 / Set Up the Valve After Install
2. Use the provided cover-opener to press and hold the
SYNC/RESET button for 5 seconds to reset the valve.
SYNC/RESET
01 / Before Install
2. Check install requirements
1. Install the valve first before powering it up.
2. No need to shut off water before changing the radiator
valve. Water will not leak.
3. Avoid installing the valve in the same room where you
have installed the boiler thermostat.
4. Install the valve within range of your Kasa smart hub if
you wish to control it using the Kasa Smart app.
5. Install the valve horizontally or vertically based on your
needs .
RA Adapter CAL Adapter
GIA Adapter M28 Adapter
3. Open the Kasa Smart app, tap + and select Smart
Thermostats. Follow the app instructions to pair the valve
and complete setup.
Install Orientation
Horizontal Installation Vertical Installation
3. Remove the cover of the valve by rotating
counterclockwise using the provided cover-opener.
4. Open the battery cover and insert two AA LR6 Alkaline
batteries. Make sure the positive and negative
terminals face the correct direction.
*Do NOT use rechargeable batteries or 1.2V AA batteries.
Don't Have a Hub?
You can adjust temperature manually.
After inserting the batteries, the valve is ready to use.
Rotate the valve to increase / decrease temperature.