Installing The Indoor Unit; Description Of The Product; Installation Warnings - Immergas MAGIS PRO 12 V2 Instructions And Recommendations

1

INSTALLING THE INDOOR UNIT

1.1

DESCRIPTION OF THE PRODUCT.

Magis Pro 12-14-16 V2 is a heat pump consisting of:
- UI MP AP indoor unit (hereinafter it will only be referred to as indoor unit);
- UE Audax Pro 12-14-16 V2 outdoor condensing unit (hereinafter it will only be referred to as outdoor unit).
Magis Pro V2 is perfectly operational only if the two units are correctly powered and interconnected.
The indoor unit was designed solely for wall mounted installations for heating and air conditioning (and to produce domestic hot water
for domestic use and similar purposes only if paired with a storage tank unit).
For normal operation is must be paired with the following outdoor units:
- UE AUDAX PRO 12 V2;
- UE AUDAX PRO 12 V2 T;
- UE AUDAX PRO 14 V2;
- UE AUDAX PRO 14 V2 T;
- UE AUDAX PRO 16 V2;
- UE AUDAX PRO 16 V2 T.
Accordingly, it is necessary to comply with all of the rules regarding safety and the use of both appliances.
1.2

INSTALLATION WARNINGS

Operators who install and service the appliance must wear the personal protective equipment
required by applicable law.
The place of installation of the appliance and relative Immergas accessories must have suitable features (technical and structur-
al), such as to allow for (always in safe, efficient and comfortable conditions):
- installation (according to the provisions of technical legislation and technical regulations);
- maintenance operations (including scheduled, periodic, routine and special maintenance);
- removal (to outdoors in the place for loading and transporting the appliances and components) as well as the eventual re-
placement of those with appliances and/or equivalent components.
Installation must be carried out according to regulation standards, current legislation and in compliance with local technical
regulations and the required technical procedures.
The wall surface must be smooth, without any protrusions or recesses enabling access to the rear part. They are not designed to
be installed on plinths or floors (Fig. 1).
7