Immergas MAGIS PRO 12 V2 Instructions And Recommendations page 69

Id
Parameter
Parameter
D.H.W.
T 02
thermostat
T 05 Ignitions timer
Delay request
T 07
from TA
T 08 Display lighting
T 09 Display
Screed
heating - days at
T 21
minimum
temperature
Screed heating
T 22
- ascent gradient
Screed
heating - days at
T 23
maximum
temperature
Screed heating
T 24 - descent
gradient
Description
Establishes the unit ignition and switch-off mode in DHW
mode.
It is enabled when the water in the storage tank goes below
the DHW set value and is disabled when the temperature
exceeds the DHW set value.
The indoor unit has an electronic timer that controls
restarting the compressor of the outdoor unit.
The system is set to switch on immediately after a request for
room air conditioning. For special systems (e.g. zone
systems with motorised valves, etc.), it may be necessary to
delay ignition.
Establishes the display lighting mode.
AU: the display lights up during use and lowers after 15
seconds of inactivity. In the event of an anomaly, the display
flashes.
OFF: the display lighting is always off.
ON: the display lighting is always on.
Establishes what the indicator displays 14 (Fig. 14).
"Summer" mode:
ON: active circulator, this displays the flow temperature,
with circulator off the indicator is off
OFF: the indicator is always off
"Winter" and "cooling" mode:
ON: circulator pump active displays the flow temperature,
pump off displays the value set on the central heating
selector.
OFF: always displays the value set on the central heating
selector
Defines the time spent at minimum operating temperature
during the active function
Defines the ascent gradient of the temperature
Defines the time spent at maximum operating temperature
during the active function
Defines the descent gradient of the temperature
Range Default
0 ÷ 20 °C 4
0 - 10 minutes 3
0 - 240
seconds (10 0
sec step)
AU - OFF
AU
- ON
ON - OFF ON
0 ÷ 7 days 3
0 ÷ 30 °C / day 30
0 ÷ 14 days 4
0 ÷ 30 °C / day 30
Value
customized
69